Information

ManualsBrandsAPEM ManualsPush Actuated Switches & ButtonsPushbutton 250 Vac 0.2 A 1 x Off/(On) IP67 momentary 1 pc(s)

56 APEM www.apem.com

IA series

Low profile pushbutton switches for harsh environments - bushing Ø 16 mm - momentary

Distinctive features - Specifications - Overview

❑

Resistant to frost, sand and hydrocarbons

❑

Tactile feedback

❑

Front panel sealed to IP67

ELECTRICAL AND GENERAL SPECIFICATIONS

• Max. current/voltage rating with resistive load : 2A 24VDC

• Initial contact resistance : 100m1 max.

• Insulation resistance : 100 M1 min. at 500VDC

• Dielectric strength : 500 Vrms

• Electrical life at full load : 1.000.000 cycles

• Panel thickness : 7 mm (.276) max.

• Total travel : 1,5 mm (.059) +/- 0,3 mm

• Typical operating force : 7N +/- 2N

• Mechanical life : 1.000.000 cycles

• Torque : 0,5 to 1Nm max. applied to nut

MATERIALS

• Case/bushing : thermoplastic

• Actuator : polyurethane

• Contacts : silver, gold plated

• Multi-wire lead AWG20,

section 0,6 mm

• Terminal seal : epoxy

PANEL MOUNTING

ENVIRONMENTAL SPECIFICATIONS

• Front panel sealing (see drawing opposite) : IP67

• Salt spray : IEC 512-6, test 11f

• Operating temperature : -20°C to +65°C

Actuator

shape

R round

Case colour

00 Black

Electrical

function

3 Normally

open (NO)

5 NC/NO

combined

SERIES

Acuator colours

1 Blue

2 Black

3 Green

5 Yellow

6 Red

7/1 White

9 Orange

Terminals

F Flying leads

Contacts

1 Silver,

gold plated

A sealing boot is available to protect the switches against frost and sand. See end of this catalogue.

Mounting accessories : Standard hardware supplied : 1 hex nut 19 mm (.748) across flats and 1 flat seal.

Knurled nut U3327 available on request.

Packaging unit : 25 pieces

➞

Flat seal

Dimensions : First dimensions are in mm while inches are shown as bracketed numbers.

09-Serie_IA-A-pages56-57.qxd:09-Serie IA-A 1/02/10 14:00 Page 56