Datasheet

B2-146 APEM www.apem.com
FP series
Fully illuminated pushbutton switches - bushing Ø 24 mm - momentary or latching
Overview
B2
FP
S
ERIES
Model
A Threaded bushing,
dia. 24 mm
A
ctuator
P Round, flat
R Round, curved
F Round, curved,
flush New!
Electrical function
1 OFF - ON
3 Normally open
(NO)
LED control and No of poles
A Non-illuminated, 1 pole
B Non-illuminated, 2 poles
C Independent, 1 pole
D Independent, 2 poles
E Independent, 1 pole, dimming LED
T
erminals
1 Solder lugs
2 Straight cable
3 Right angle
cable, length
300 mm
Actuator colour
1 Blue
2 Black
3 Green
4 Grey
5 Yellow
6 Red
7 White/natural
9 Orange
ABOUT THIS SERIES
On the following pages, you will find successively :
model structure of switches and options in the same order as in above chart
Dimensions : first dimensions are in mm while inches are shown as bracketed numbers.
Mounting accessories : Standard hardware supplied : 1 hex nut and 1 O-Ring
Packaging unit : solder lug versions : 20 pieces - cable versions : 1 piece
NOTICE : please note that not all combinations of above numbers are available.
Refer to the following pages for further information.
Bezel colour
1 Blue
2 Black
3 Green
4 Grey
5 Yellow
6 Red
7 White/natural
LED colour
X Non-illum.
A Blue
B Green
C Red
D Yellow
E White
F Red/green
G Red/blue
Marking
X No marking
1 Pad printing
2 Laser
Symbols
See end of series
LED resistor
0 No resistor
supplied
1 12VDC resistor
2 24VDC resistor
5 15VDC resistor
6 30VDC resistor
Contact mat.
2 Silver
4 Silver, gold
plated