Datasheet

www.apem.com
BF series
Paddle controllers
SPECIFICATIONS
Note: The company reserves the right to change specifications without notice.
A
All parameters shown are based on a standard configuration and are provided for guidance only.
Please refer to Apem for assistance on how to achieve the best performance from your chosen configuration.
MECHANICAL
Materials Employed – Polyetherimide, Polycarbonate, Stainless Steel
Weight – 50g
Mechanical Operating Angle – +/- 25 Degrees
Max Load to Mechanism – Vertical: IK08 (BSEN62262:2002)
Horizontal: 75N (16.86lbf)
ELECTRICAL
Gain (Output Voltage Span) – +/-10% x V to +/-50% x V
Output at Center – V/2 +/- (5% x Gain)
Power Supply – 5V +/-0.5V Transient free
Switch Outputs – Open Drain, pulled high within control via 1K5 to 5V,
and smoothed to 0V with 100nF
Sensor Type – Hall effect
Current Consumption – <20mA
Loads – Minimum 10K, preferred 100K+
ENVIRONMENTAL
Storage – -40°C to 70°C (-40°F to 158°F)
Operating Temperature – -25°C to 70°C (-13°F to 158°F)
Seal Above Panel – IP67 (Gasket fitted as standard)
EMC Emissions – Complies with EN 61000-6-3:2001 CISPR 22:2005 Class
B 30MHz - 11GHz
Life Cycles – 5 million cycles sprung version only. Detents rated to
2 million cycles
ESD – Complies with EN61000-4-2 (extended)
+/-8KV (20 contacts) & +/-15KV (20 air discharges)
EMC Immunity – 100V/m, 80MHz-2.7GHz, 1KHz 80% sine wave
modulation, EN 61000-4-3 (extended)
Vibration – 100Hz - 200Hz @ 0.13g²/Hz, total 3.6gRMS (1 Hour in
each of the three mutually perpendicular axes)