Datasheet

APEMwww.apem.com
Note: The company reserves the right to change specifications without notice.
MOUNTING CUT-OUT
MOUNTING CUT-OUT
MOUNTING OPTION A - PANEL CUT-OUT & MOUNTING INSTALLATION
MOUNTING OPTION B - PANEL CUT-OUT & MOUNTING INSTALLATION
When mounted this way the panel acts as the bezel and no
separate bezel is needed. M3 machine screws are recommended.
NOTES:
– When sub panel mounting, great care should be taken not to damage the boot, or any of the mechanism under the boot.
All panel cut-outs should be free from sharp edges and swarf that may damage the boot.
– Some handles are larger then the recommended panel cut-out, in which case drop-in mounting must be specified.
35.80
(1.41)
35.80
(1.41)
Ø34.00
(1.34)
Ø3.20 x 4
(0.13 x 4)
35.80
(1.41)
35.80
(1.41)
Ø35.00
(1.38)
Ø3.20 x 4
(0.13 x 4)
The joystick flange is mounted beneath the panel and the base of
the boot must be brought through the panel cut-out and held in
place with the circular bezel (option 4). For panel thicknesses of
3mm, M3 x 16 countersunk machine screws are recommended.
8000 series
Ruggedized switch joysticks
Overview