Datasheet

www.apem.com
8000 series
Ruggedized switch joysticks
MOUNTING INSTALLATION
Note: The company reserves the right to change specifications without notice.
MOUNTING CUT-OUT
MOUNTING CUT-OUT
MOUNTING OPTION A - PANEL CUT-OUT & M OUNTING INSTALLATION
MOUNTING OPTION B - PANEL CUT-OUT & MOUNTING INSTALLATION
When mounted this way the panel acts as the bezel and no
separate bezel is needed. M3 machine screws are recommended.
The joystick flange is mounted beneath the panel and the base of
the boot must be brought through the panel cut-out and held in
place with the circular bezel (option 4). For panel thicknesses of 3mm,
M3 x 16
countersunk machine screws are recommended.
Note: When sub panel mounting, great care should be taken not to damage the boot, or any of the
mechanism under the boot. All panel cut-outs should be free from sharp edges and swarf that may
damage the boot.
.
35.80
(1.41)
35.80
(1.41)
Ø31.00
(1.22)
Ø3.20 x 4
(0.13 x 4)
35.80
(1.41)
35.80
(1.41)
Ø35.00
(1.38)
Ø3.20 x 4
(0.13 x 4)