Datasheet

www.apem.com
8000 series
Ruggedized switch joysticks
DIMENSIONAL DRAWINGS
Note: The company reserves the right to change specifications without notice.
NOTES:
1. Dimensions are in mm/(inch)
2. The dimensions shown are for a generic 8000 Series with the conical E type handle. For specific
dimensions of this or any other configuration please refer to the Factory.
35.80
(1.41)
35.80
(1.41)
35.80
(1.41)
35.80
(1.41)
Ø41.00
(1.61)
Ø3.20 x 4
(0.13)
3.20*
South
North
East
West
40.00
(1.57)
42.00
(1.65)
31.00
(1.22)
62.00
(2.44)
4.50
(0.18)
LEADS EXIT TO THE EAST
VIEWED FROM ABOVE
The joystick is dropped into the panel cut-out. The joystick and boot must
be kept in place by bezel (option 6 & 7). For panel thickness of <3mm,
M3 x 16 countersunk machine screws are recommended.
DROP IN MOUNTING - PANEL CUT-OUT & MOUNTING INSTALLATION
GENERAL DIMENSIONS
POLARITY