Datasheet

APEMwww.apem.com
Note: The company reserves the right to change specifications without notice.
1000HE series
Switch joysticks for harsh environments
Overview
NOTES:
– Dimensions are in mm/(inch). Images shown are for illustration purposes only.
Existing 1000 series
22mm (0.87in) bushing
and panel cut-out.
Ensure that the rubber
O-ring is in position before
threading the top section on.
Handle Identifier (BE)
External Boot
Identifier (8)
Apply the assembled base
through the mounting cut-out
in the panel (shown above left)
Kumho Sealing Boot
Oil, Petroleum & UV resistant
Kumho Sealing Boot
Oil, Petroleum & UV resistant
Machined HEX finishing NUT -
Apply torque of 1-1.5 Nm to seal.
Apply Loctite 270
Note: Double Pole Version is 27.5mm (1.08in) deep below panel
Note: Users may still select their choice of V4 Micro switch and
number of poles according to the standard 1000 series option list.
Users may also select the joystick to have an open square gate
(when no limiter is fitted) or a metal slot or cross limiter factory fitted.
Existing 1000 series
22mm bushing and
panel cut-out.
Ensure that the rubber
O-ring is in position before
threading the top section on.
Handle Identifier (BH)
Apply the assembled base
through the mounting cut out
in the panel (shown above left)
Nitrile Rubber O-Ring
Machined HEX finishing NUT -
Apply torque of 1-1.5 Nm to seal.
External Boot
Identifier (8)
Apply Loctite 270
See following page for
Installation Instructions.
See following page for
Installation Instructions.
Nitrile Rubber O-Ring
23.50
(0.93)
85.00
(3.35)
30.00
(1.18)
80.00
(3.15)
44.00
(1.73)
23.00
(0.91)