Datasheet

PIN FUNCTION COLOR
1 0V Black
2 Center Tap Reference Green
3 Z Axis Output - Where Specified Purple
4 Y Axis Output Yellow
5 X Axis Output- Where Specified Blue
6 +V Red
7 Center Detect Orange
8 Pushbutton Orange
9 Pushbutton Orange
CONNECTIONS
The joystick is fitted, as standard, with 150mm long
BS6360 rated cables and an industry standard 2.5mm
pitch connector(s). Further non-standard connectors and
cable options are available upon request.
CONFIGURATIONS 1 & 2
Joysticks are supplied with a seven way connector as
standard. If the joystick is specified with a pushbutton
handle, the connector will be nine way.
Robust proportional fingertip controllers •
non-contacting Hall effect technology
3000 series
PIN FUNCTION COLOR
1 0V Black
2 Center Tap Reference Green
3 No connection
4 Y Axis Output Yellow
5 X Axis Output- Where Specified Blue
6 +V Red
7 No connection
• Shaft: Stainless steel
• Boot: Neoprene
• Handles:
BL, E, Q, AL - Nylon
AR - Aluminum
K - ABS
T - Stainless steel
MATERIALS
For details on configuration 5 pinout, please contact
Customer Support.
CONFIGURATIONS 3 & 4
Joysticks are supplied with two completely independent
cable assemblies for a truly dual system.
When mounting the joystick, care should be taken to
site it in a position that does not make it vulnerable
to damage when in use. If the joystick is intended
for use in a handheld enclosure then care must be
taken to protect the joystick from damage caused by
dropping. Basic precautions such as mounting it at
the lightest end of the enclosure so it doesn’t hit the
ground first or by protecting it with a guard should
always be implemented for long term reliability.
The body of the joystick, on the underside of the
panel, must not be subject to water spray, excessive
humidity or dust. Some handles may be larger than
some panel cut-outs. This may restrict the choice of
mounting and bezel options. Please refer to APEM
for assistance.
MOUNTING
2
JOYSTICKS