Datasheet

8
3000 SERIES - JOYSTICKSCONTACTLESS
MOUNTING INSTALLATIONS
35.80
35.80
Ø35.00
Ø3.20 x 4
35.80
35.80
Ø31.00
Ø3.20 x 4
MOUNTING CUT-OUT
MOUNTING CUT-OUT
MOUNTING OPTION A - PANEL CUT-OUT & MOUNTING INSTALLATION
MOUNTING OPTION B - PANEL CUT-OUT & MOUNTING INSTALLATION
When mounted this way the panel acts as the bezel and no separate
bezel is needed. M3 machine screws are recommended.
The joystick flange is mounted beneath the panel and the base of the
gaiter must be brought through the panel cut-out and held in place
with the circular bezel.
For panel thicknesses of <3mm, M3 x 16 countersunk machine screws
are recommended.
Note: When sub-panel mounting, great care should be taken not to damage the gaiter, or any of the mechanism under the
gaiter. All panel cut-outs should be free from sharp edges and debris that may damage the gaiter.
www.apem.com
Note: The company reserves the right to change specifications without notice.