Datasheet

www.apem.com
1000 series
Compact switch joysticks
DIMENSIONAL DRAWINGS - continued
Note: The company reserves the right to change specifications without notice.
V3 SCREW MOUNT
V4 SCREW MOUNT
V4 BUSH MOUNT
36.00
(1.42)
36.00
(1.42)
Ø2.80 x 4
(0.11)
Ø2.80 x 4
(0.11)
Ø20.00
(0.79)
Ø20.00
(0.79)
45.50
(1.79)
45.50
(1.79)
22.00
(0.87)
9.20
(0.36)
20.00
(0.79)
NOTE:
The joystick is mounted from beneath the panel
using the 4 x M2.5 machine screws, supplied with
the joystick.
Supplied as standard with the joystick is a round
bezel which may be fitted (according to customer
preference) to finish the front face of the panel.
Fitting the bezel is optional, and is not necessary if
the panel cut-out finishes the panel.If fitting the
bezel is selected then the panel cut out should be
toleranced such that the bezel is an interference fit.
Additionaly bonding the bezel is recomended.
NOTE:
The joystick is mounted from beneath the panel.
Supplied as standard with all bush mount joysticks
is an adhesive P.V.C. sealing gasket. This should be
fitted between the joystick and the panel, in
applications where a good seal is needed.
NOTE:
The joystick is mounted from beneath the panel
using the 4 x M2.5 machine screws, supplied with
the joystick. Supplied as standard with the joystick
is a round bezel which may be fitted (according to
customer preference) to finish the front face of the
panel. Fitting the bezel is optional, and is not
necessary if the panel cut-out finishes the panel.
If fitting the bezel is selected then the panel cut out
should be toleranced such that the bezel is an
interference fit. Additionaly bonding the bezel is
recomended.
MOUNTING CUTOUT DIMENSIONS AND INSTALLATION
LIMITERS AND BEZEL SET
16.50
(0.65)
4.00
(0.16)
22.00
(0.87)
45°
24.50
(0.96)
20.00
(0.79)
18.00
(0.71)
2.55
(0.10)
NOTES:
1. Dimensions are in mm/(inch)