Phau Ntawv Qhia

ManualsBrandsAPELO ManualsLED LightAPELO A1 Underwater LED Light

Drilling and Installation

Any penetration through a hull is a potential entry point for water. If in any doubt at all, please consult a professional for advice. All

holes should be sealed correctly with the correct sealing product. Hella marine recommends 3M 4200 Semi-permanent polyurethane

adhesive.

The adhesion of the lamp is primarily via the adhesive used. The screws give the right compression to the adhesive between the lamp

and the transom, while allowing the adhesive to cure. Even so, it is important to ensure the screws are fastened with the correct torque.

When drilling pilot holes in any type of material, in most instances, you will require a drill bit sized larger than the minimum diameter of

the screw, but smaller than the maximum thread diameter. It is recommended to err on the side of caution and to begin smaller, then

go larger if required. Always try the screw without the lamp in place rst. If the torque required feels excessive, back out and make

slightly larger.

Using the Drilling Template:

The drilling template is the last page of this instruction sheet. Remove page and use to nd approximate location for lamp. Once you

are happy with the location, attach the template using tape to hold against the transom.

Press a cent ring punch against the mounting screw holes to mark the transom for screw hole location, and do the same for the central

cable hole.

Remove the template and drill the holes, ensure the appropriate sized drill bits are used.

For breglass hulls, to prevent damaging gelcoat, use a countersunk bit to begin the hole and create a bevelled edge to prevent

damage.

For Bronze lamps only; The lamp is supplied with bronze headed screws. These are much softer than typical screws so extra care must

be taken when driving screws, to prevent screw heads from shearing o󰀨.

If Anti-Foul is required, Hella marine recommends ‘LightSpeed’. Refer to instructions supplied in the pack.

Wiring

Important! Always use the smallest fuse that is rated to the size of the load. Refer to the specication table to check the requirements

for exact lamp you have purchased.

Blue/White Lamps (PN 016.145-xxx and 016.147-xxx)

To power up, simply connect the Red wire to Positive and the Black wire to Negative, through an ON/OFF switch. The default function

will be the ‘Edge light’ for the A2 lamps and the Bright White Light for the A1 lamps.

To switch to the next function, simply power the lamp o󰀨 and on again quickly.

Sequence Output A2 Lamps Output A1 Lamps

1 Edge Light White light, ramping to full intensity

2 White light, ramping to full intensity Blue Light, ramping to full intensity

3 APELO ‘Fish mode’ Strobe, White LEDs Starts again at sequence 1

4 Blue Light, ramping to full intensity

5 APELO ‘Fish mode’ Strobe, Blue LEDs

6 Starts again at sequence 2

Lamp Wire Lamp Function

Red Positive, Switched

Black Negative, Permanent

RGB Lamps (PN 016.146-xxx and 016.148-xxx)

To display the full spectrum of color, and color changing modes, an external RGB controller is required. For that purpose, Hella

recommends the Fusion MS-RGBRC, available at most marine outlets.

If an RGB controller is not available, or is not required, an Apelo RGB lamp may be directly connected to provide multi color output.

Refer Instructions

Anweisungen ﬁnden

Consulter les instructions

Consulte las instrucciones

15.5mm

5/8"

95mm

ST4.8

10G

TOP