User`s guide

Installation 12
Wall support (sold apart)
If you have chosen to install the Maxpad™ on the wall, follow the following steps:
1.Removethefourpiecesthatarepartofthesupport,identiedbythecodes“1A”,
“1B”,“2A”e“2B”therespectivescrewsandplugs;
2. Remove the upper protection from the MaxpadTM (where this manual was place)
andputitontheoorinverted;
3. In two persons remove Maxpad™ from the box and place it on the foam with the
screen facing down. At this point it is important to the careful so that the module of
the camera is over the relief cut, avoiding damage to the device;
1B1A