Owner`s manual

SEAT STAYS
PROBLEM: “There’s no traction/the kart is
oversteering coming from the apex out of a corner”
Solution: Mount seat stays on either side of the
seat. In certain applications 2 sets of seat stays
can be fitted.
PROBLEM: “The kart is unsettled over bumps”
Solution: Remove the seat stays.
PROBLEM: “The kart is slow coming off corners, and is pushing from the rear”
Solution: Remove the seat stays.
NOTE: Additional seat stays are available which fix to the axle bearing flanges and the top
section of the seat. Running four seat stays will significantly obtain a lot more rear grip.
ADJUSTABLE/REMOVABLE
TORSION BARS AND CLAMPS
PROBLEM: “There’s no traction/the kart is oversteering coming from the apex out of a corner &
also on the entry into a corner”
Solution:
1. Running the rear torsion bar ‘full stiff’ (i.e.
with the blade of the torsion bar set vertically
to the track’s surface) will maximize rear
mechanical grip as well as reducing rear
chassis roll.
2. When karts are fitted with a removable side
torsion bar or are equipped with tensioning
bolts on the fourth rail, tighten the tensioning
bolts completely.
16 SEAT STAYS - ADJUSTABLE/REMOVABLE TORSION BARS & CLAMPS