Owner`s manual

REAR WHEEL HUBS
(
continued
)
NOTE: If your Arrow is fitted with a 40mm axle the wheel hubs incorporate a unique design
with a wheel-locating insert. Fit the insert if you have your wheel hubs over the end of
the axle and remove the insert if you want to slide your wheel hubs further inwards for a
narrower rear track. Important: To remove the insert slide your wheel hub onto the axle
and tap the hub against the end of the axle until the insert falls out. When the insert is
fitted ensure it is fitted fully into the hub before fitting your wheel. If the insert is sitting
against the end of the axle and protruding from the wheel hub this will stop your wheel
from fitting correctly and will cause the wheel to come loose.
CRASH & SIDEPOD BAR ADJUSTMENT
PROBLEM: “Understeer from the apex and out of the corner and/or the rear of the kart feels
stuck to the track, making it slow off corners”
Solution: Loosen, but do not remove the bolt
at the front mounting point of both side-pod
supporting bars to the chassis.
PROBLEM: “Lacking all round grip/bite into the track”
Solution: Tighten side-pod mounting bolts.
Side Pod Bars:
Have these tightened for most conditions. Loosening
these will reduce grip and can also assist in reducing
understeer.
Rear Crash Bar:
The rear crash bar must always be kept securely
tightened, unless using Arrow’s Rear Crash Bar
Loosening System. This unique system allows the
rear crash bar to be run ‘loose’ in order to reduce grip,
while maintaining safe attachment and complying with
racing rules.
REAR WHEEL HUBS - CRASH & SIDEPOD BAR ADJUSTMENT 9