Owner's Manual

INCOMING WATER SUPP

OUT GOING

WATER TO HOUSE

CONNECT DRAIN LINE

Shut o Valve (Optional)

INPUT

OUTPUT

This is an overview for system installation.

5. Please Set Time of Day on system control valve once installation is completed.

SYSTEM TANK INSTALLATION

1. Turn off water supply where it enters the building.

2. The bypass valve comes complete with O-rings, split rings and black quick connector nuts. Install the

bypass valve by pressing the valve onto the head of the tank and hand tighten both black quick connect

nuts.

3. When running the piping for the system, connect the incoming water supply to the DOWN-FLOW INLET

(Input) side. Connect the water supply line going into the house to the UP-FLOW INLET (Output) side.

See Figure. 6

4. Use the appropriate fitting connection to the bypass valve. Brass Sweat Adapter Kit (WTS-ADPT-

V300702LF) for copper piping and PVC Solvent 90 degree Adapter Kit (WTS-ADPT-V3007) for PVC Pip-

ing. (Follow the instructions supplied with the fittings for assemble).

a. Important: If soldering connections are used, do not install the O-rings, split rings and black

quick connect fittings and piping. Allow solvent cements to set before installing the black quick

connector nut, split ring and O-rings.

b. Important: If PVC solvent connections are used, use solvent cements and primers to connect

fittings and piping. Allow solvent cements to set before installing the black quick connector

nut, split ring and O-rings.

Figure. 6