Owner's Manual

6
For initial set-up or to make adjust-
ments, please complete the steps
as shown. Access this mode by
pressing SET and for approx-
imately 3 seconds. The number of
days between regenerations may
need to be varied based on usage
and water conditions. (This step will
not appear if the 7-day clock op-
tion is selected.)
1. Accessed by pressing SET and simultaneously
for about 3 seconds.
2. Set Regeneration Time Hour. Set the time for re-
generation to start. Press SET to go to the next
step.
3. Set Regeneration Time Minutes. Press SET to go to
the next step.
4. Set number of Days between regeneration cycles.
5. Press SET to complete and return to normal oper-
ation.
TO SET TIME OF REGENERATION AND DAYS BETWEEN REGENERATION
SET
SET
SET
SET
Rege
n
Min. Fill
Rege
n
Ti
me
Time
PM
Days
To
Regen
Rege
n
Min. Fill
Rege
n
Ti
me
Time
PM
Days
To
Regen
Rege
n
Min. Fill
Rege
n
Ti
me
Time
PM
Days
To
Regen
SETTING UP TIMER CONTROL VALVE Please Note: For complete instructions refer to manual.
When the system is operating one
of two displays will be shown: time
of day or days until next regenera-
tion. Pressing or button will
toggle between the two choices.
GENERAL OPERATION
TO SET TIME OF DAY
SET
Regen
Min. Fill
Regen
Ti
me
Time
PM
Days To
Regen
Regen
Min. Fill
Regen
Time
Time
PM
Days
To
Regen
SET
or
Arrow will point to Regen
if a regeneration is
expected “Tonight.”
In the event of a prolonged pow-
er outage, time of day flashes, in-
dicating that it needs to be reset.
All other information will be stored
in memory no matter how long the
power outage. Please complete the
steps as shown to the right. To ac-
cess this mode, press “Set.”
SET
Regen
Min. Fill
Regen
Ti
me
Time
PM
Days To
Regen
Regen
Min. Fill
Regen
Ti
me
Time
PM
Days To
Regen
1. Accessed by pressing SET for approximately 3 sec-
onds.
2. Adjust hour with or . With 60 Hz line fre-
quency detection on power-up, timekeeping is 12
hour with PM indicator. With 50 Hz line frequency
detection on power-up, timekeeping is 24 hour
without the PM indicator. Press SET to go to the
next step.
3. Adjust minutes with or .
4. Press SET to complete and return to normal op-
eration.