Owner's Manual

POST INSTALLATION SYSTEM OVERVIEW

1. After the installation of the Whole House Water Treatment System, CHECK FOR LEAKS. If you notice

water leaking at the control head, turn the head to tighten it up. The tank head is hand tighten, do not

over tighten the head. Do not over tighten any of the fitting during installation. All fittings should be

hand tightened.

2. The bottom of the tank is round, and uses the tank stand to stand the tank upright. If the tank leans to

one side simply raise the tank in the air and set it on the ground until the tank stands vertical. You should

do this before filling the tank with water, as the tank will be heavy when filled with water.

3. After installation the arrows on the bypass valve may be pointing in different directions than shown in our

diagrams (See Figure 7 & 8). If this is the case simply pull up on the Red Arrows and turn them around.

4. Once the installation is complete, remove the protective film around the Stainless Steel tank jacket.

For Immediate Regeneration:

Press and hold and simul-

taneously until valve motor starts

(typically 3 seconds).

MANUAL REGENERATION

NOTE: If you need to initiate a

manual regeneration, either imme-

diately, or tonight at the pre pro-

grammed time (typically 2 a.m),

complete the following steps.

Arrow will point to Regen if a

regeneration is expected “Tonight.”

SET

Regen

Min. Fill

Regen

Time

Days To

Regen

For Regeneration Tonight:

Press and release and simul-

taneously (notice that arrow points

to Regen).

ERROR MESSAGES

If the display shows “E1,” “E2,”

“E3”, or “E4” (for error), call a ser-

vice technician.

SET

Regen

Min. Fill

Regen

Time

Days

Regen