Service manual

3
Thank you for choosing Watergeneral Reverse Osmosis Water Systems. You now own a superb Reverse Osmosis (RO)
system that effectively reducing most contaminants, organic and inorganic compound, unwanted taste and odor from tap
water. It is designed to transform your tap water into distill water.
Read carefully and follow the instruction in this manual before proceeding with actual installation. Failure to do so could
result in personal injury or damage to the equipment or other properties. Be sure to follow any special plumbing codes in
your area.
CHECK LIST:
1. Reverse Osmosis Unit
2. Water storage tank
3. Installation kit consists tank ball valve, drain saddle valve, feed water adapter, feed water needle valve, faucet
assembly, tubing, tube inserts
4. Installation manual
INSTALLATION KIT:
1. Chrome dispensing faucet
2. Tank ball valve or On/Off valve
3. Drain saddle clamp
4. ¼” tubing
5. Bottom filter housing wrench
6. tube insert *
7. ½” feed water adapter
8. chrome ball valve for water supply
* NOTE: Item #6 tube inserts are not required in the installation, but you can put them in three places; (1) tubing
connection at 1
st
stage filter, (2) tubing connection at tank ball valve, (3) tubing connection at dispensing faucet.
RECOMMENDED TOOLS LIST
Variable speed drill 1/8” ¼”, 7/16”, ½”, and 5/8” drill bit
5/8, 9/16 open-end wrench, or adjustable wrench, pliers Phillips screwdriver
Utility knife, or scissor Teflon tape
OPERATING PARAMETER
• Working pressure: 40 to 80 psi feed water pressure required. If input pressure is below 40 psi, a booster pump or a
permeate pump is needed. We have a RO system with built-in permeate pumps, and we also carry booster pumps.
If the input water pressure is above 80 psi (you must use a pressure regulator to step down the pressure). We
also carry small pressure regulators just for the RO system.
• Working temperature: 100 ~ 40 deg. F ( 37 ~ 4 deg. C )
• If feed water has hardness level above 300 ppm, we recommend putting a water softener prior to the RO system.
• If feed water has iron, rust problem, we recommend putting an iron filter prior to the RO system.
• If feed water has bacteria problem, we recommend putting an ultra violet sterilizing system prior to RO system.
WARNING: Do not use this RO+DI system alone to treat water with bacteria problem or water source with unknown
quality.
WARNING: Do not connect HOT water source to this unit.
WARNING: Incorrect installation will VOID the warranty.
WARNING: Input pressure must not exceed 80 psi. Pressure regulator must be installed to reduce pressure.
WARNING: Using other brand of replacement filters and parts will void the warranty.