Owner`s manual

PART II. PLACING THE MEMBRANE INTO THE MEMBRANE HOUSING

This system has been wet tested in the factory, and the RO membrane is sealed to preserve

freshness.

1. Locate the blue membrane and remove it from the plastic bag.

2. Locate the Membrane Housing (labelled “Membrane” ) on the system.

3. Fig. 4A

1. Disconnect the RED tubing from the membrane housing’s cap. Do so by un-

screwing the plastic nut on the fitting.

2. Remove the membrane housing cap (turn counterclockwise).

3. See Fig 4B. Insert membrane all the way into the housing tightly with the correct

side going in first as shown below.

Note: Make sure the membrane is inserted in the correct way as shown in Fig 4B!

Fig. 4A

Fig. 4B

( Follow these same procedures for future membrane changing and maintenance. )

4. Close the cap of the housing and reconnect tubing as before.

1. First unscrew plastic nut

to take tubing out

2. Unscrew membrane housing

cap (counter clockwise)

3. Insert Membrane