Owner`s manual

THERE ARE THREE PARTS TO INSTALLING THE RO SYSTEM:

Part I. Assemble the filters and housings onto the main system

Part II. Placing the Membrane into the membrane housing

Part III. Installing the system

PART I. ASSEMBLE THE FILTERS AND HOUSINGS ONTO THE MAIN SYSTEM

Remove plastic/paper wrappings on the 3 filters, put them into the 3 housings, and assemble the

housings onto the main system as follow:

Fig. 1 Stand the 3 housings upright. Make sure each housing has a rubber O-ring in its

groove.

Put the “Puretrex 5 micron” sediment filter into the “1

stage” housing on the right.

Put the “Matrikx +CTO” carbon filter into the “2

stage” housing in the middle.

Put the “Matrikx +CTO” carbon filter into the “3

stage” housing on the left.

Fig. 2 Starting from the 3

stage housing on the left, hand twist the housing onto the main

system turning counterclockwise, one by one, for all 3 housings.

Fig. 3 Use the wrench provided to completely tighten the housing starting from 1st-stage.

Repeat this step for the 2

stage housing in the middle, and for the 3

stage hous-

ing on right.

Note: For some people it is easier to use the wrench with the system laid down

(face up).

Fig. 1 Fig. 2 Fig. 3

3rd

Stage

2nd

Stage

1st

Stage

Use

Wrench