Owner`s manual

Thank you for choosing APEC reverse osmosis sytems.

You now own the finest water filter in America.

Please read and become familiar with instructions and parts needed before proceeding with

the installation.

BEFORE INSTALLATION:

Inspect the system:

Please take the system and all the components out of the box. Inspect the system and all the con-

nection fittings carefully, make sure nothing is damaged during shipping. If any part is cracked or

broken, please do not proceed with the installation and contact APEC or your distributor for an

exchange or diagnosis.

Recommended tools list:

 Variable speed drill

 Drill bit: ¼” (for the waste line), 1/8” (as pilot, not mandatory), and ½” (for standard

faucet hole, air-gap faucet requires 1&1/4” hole)

 5/8”, 9/16” open-end wrench, or adjustable wrench, pliers

 Phillips screwdriver

 Utility knife, or scissors

 Teflon tape

Operating Parameter

 Operating pressure: 100psi maximum

 Feed water temperature: 40 – 100 degree F (4-37 degree C)

 Do not connect this unit to hot water source

 Install the RO in a sheltered environment, avoid exposure to hot and cold weather or under

direct sun light.

This manual is copyrighted by APEC Inc. Under the copyright laws, this manual may not be reproduced in any form, in

whole or part, without the prior written consent of APEC Inc.