System information

Sensor to Camera
This mapping allows you to match sensors
and cameras.
Procedure Using the Remote Controller
or Control Panel:
1. In SETUP, select Mappings->Sensor To
Camera.
2. In Sensor To Camera Setup, use [UP], [DOWN], [LEFT] or [RIGHT] to navigate through the menu.
3. Use [ENTER], [SELECT], [+] or [-] to change the values. An “x” means mapped. Note that all chang-
es you make are always saved.
4. When you are done, press [SETUP] or [BACK].
Note: You can map more than 1 camera per sensor. Conversely, you can map more than 1 sensor per camera.
52
Sensor to PTZ
This mapping allows you to match sensors
to PTZ cameras. If a sensor is matched
with a PTZ camera, then when the sensor is
triggered, the PTZ camera will move to the
preset dened under Preset On and once
the sensor is de-activated, the PTZ camera
willmovetopresetdenedunderPresetOff.
The Dwell Time indicates the length of time
from when the PTZ camera moves from Present On to Preset Off
Procedure Using the Remote Controller or
Control Panel:
1. In SETUP, select Mappings->Sensor To
PTZ Camera.
2. In Sensor To PTZ Camera Setup, use
[UP], [DOWN], [LEFT] or [RIGHT] to
navigate through the menu.
3. Use [ENTER], [SELECT], [+] or [-] to
change the values. There are 9 possible
presets. (See SETUP->PTZ->Camera.)
An “x” means there is no preset selected.
Note that all changes you make are always saved.
4. When you are done, press [SETUP] or [BACK].
NOTE: Dwell settings can be adjusted from 5 to 90 secs. Please ensure that sensors are enabled; refer to page 49.
Camera to Relay
This mapping allows you to match cameras
and relays.
Procedure Using the Remote Controller
or Control Panel:
1. In SETUP, select Mappings->Camera
To Relay.
2. In Camera To Relay Setup, use [UP],
[DOWN], [LEFT] or [RIGHT] to navi-
gate through the menu.
3. Use [ENTER], [SELECT], [+] or [-]
to change the values. An “x” means
mapped. Note that all changes you
make are always saved.
4. When you are done, press [SETUP] or
[BACK].
Note: You can map more than 1 camera per re-
lay. Conversely, you can map more than 1 relay
per camera.
Sensor to Relay
This mapping allows you to select which
relay(s) will be activated when selected
sensor is triggered.
Procedure Using the Remote Controller
or Control Panel:
1. In SETUP, select Mappings->Sensor
To Relay.
2. In Sensor To Relay Setup, use [UP],
[DOWN], [LEFT] or [RIGHT] to navi-
gate through the menu.
3. Use [ENTER], [SELECT], [+] or [-]
to change the values. An “x” means
mapped. Note that all changes you
make are always saved.
4. When you are done, press [SETUP] or
[BACK].
Note: You can map more than 1 sensor per relay. Conversely, you can map more than 1 relay per sensor.
53