System information

Chapter 5: APEC Network Operation
97
Fig. 5-41
On Fig. 5-41, there are some selections:
1. Dimension – You can select 320x240,640x480,800x600,1024x768 to meet the resolution of
your VGA screen.
2. Display – You can select 1/4/8/16 cameras here. This is the number of camera video you want to
show on the screen.
3. Camera – Selection here is related to Display. If you set “16 cameras” at “Display”, then, you
have on choice here only, “ Camera 1-16”. Only when the “Display” filed is set less than 16
cameras, then you have choices here.
4. Bandwidth – Click “Low” or “High” based on your remote connection link speed to AP-5004.
5. Status bar selection – Here you can select “Data”, “Motion”, “GPI” to show different status. On
Fig. 5-33, you see this field is selected as “Data” and the status bar is full of “Blue”. That means
video data was written continuously within this hour. If you select “Motion”, then, you may get
status bar shown up like . You can see the white gaps among yellow color.
That means, there was NOT always motion detected. Same thing happens to “GPI” selection.
6. Speed selection – You can select playback speed at 1x/2x/4x/full or 1/2x, 1/4x,1/8x.
7. Snapshot – When clicked, the screen will pop up camera selection, you then select the camera
that you want to do snap shot to save the image. File name of the image is assigned automatically
to be “yyyymmddhhmmnnss.jpg”
8. Save to disk – When clicked, you can save the video of a particular camera to disk. You need to
speed selection
status bar selection
status bar
stop
pause
step forward
play
snap shot
save to disk( one camera Only)
see Fig. 5-42