System information

Chapter 5: APEC Network Operation
81
Fig. 5-13
5.6.3 Alarm & remote control
The GPI state can be NO(normally open) or NC(normally close). When NO is selected as shown
below, AP-5004 generate alarm if the GPI state changes to “close” by external event. There are maximum
8 GPI and GPO points in a AP-5004 depends on the IO device installed. The state of GPO can be “ON”
or “OFF” . When “OFF” is selected as below, it means the output points are “open” and when “ON”, it
means “close”.
Fig. 5-14
5.6.4 System configuration
Use the System Configuration page to set the following parameters for the AP-5004.
• Running mode – Select “Network Mode” if AP-5004 is connected to local LAN through its RJ-45
LAN port. Select “ISP Mode”, if it is connected to Internet via dial up telephone.
• TCP/IP setting – This is normally for “Network Mode” only because when “ISP Mode”, the IP, DNS,
Gateway and Subnet Mask are all assigned by Internet Service Provider.
• ISP setting – Fill in for dial-up connection to Internet through telephone line.
click to make the changes into effect