System information

Chapter 4: IR Remote Control Operation
70
track is played. Use the Prev Page and Next Page buttons on the remote control to move
between pages.
4.5.1 Playback list
Use the Playback list function to display a list of all recordings stored on the AP-5004 as follows.
1. Use the Up and Down arrow buttons to select a recording to play back. The alarm condition which
caused the file to be recorded is indicated in the list. For instance, in the screen shot shown here, the letter
M next to a file indicates that the file was recorded after motion was detected by the camera. “A”
indicates that the file was recorded after a GPIO event. An asterisk (*) before the date indicates that the
file is locked.
2. Press the OK button to confirm. The chosen recording is played back.
3. Press the Display button on the remote control to display various properties of the recorded file. The
date and time of recording are displayed in the upper right corner.
Progress - A one hour time line is displayed at the bottom of the screen with the moving orange line
indicating the status of playback.
Recorded Data - The aqua colored portion is where there is recorded data in that hour . A full blue line
means that the whole hour interval was recorded.
GPI - The screen shows where alarm triggers were generated. The red bar shows the trigger. To move to