System information

Chapter 4: IR Remote Control Operation

• Disable all area –set no area is motion detect area.

3. Select the Enable field and use the Left and Right arrow buttons to toggle between Yes , to enable the

motion detection feature, and No, to disable it.

4. Select the Sensitivity choice and use the Left/Right arrow buttons to decrease/increase the sensitivity.

We recommend that you keep the sensitivity level to its default setting. If the sensitivity level is

adequate, an orange square is displayed in the upper left-hand corner of the screen when motion is

detected.

5. Select the Set Detect Area option and press the Right arrow button to configure the area as follows:

i. The highlighted area in red is the area monitored by motion detection. Use the Arrow buttons to

move the cursor.

ii. Press the OK button to cut off any areas where you want to disable motion detection. If you want

motion detection enabled in the entire field of vision of the camera, leave the screen completely red.

iii. Press the Cancel button to return to the previous menu when done.

6. Select the Save option and press the OK button to save all your changes.

7. Use the Prev Page and Next Page buttons to move to the motion detection menus for all connected

cameras.

8. Press the OK button when settings are correct. You need to provide E-mail details if you want an

E-mail to be sent when an alarm occurs.

4.4.4 GPI Trigger

Use the GPI Trigger function to enable recording video from specified cameras when triggered by an

external alarm (GPI) connected to the system.

4.4.5 Text Record

1. Use the Up and Down arrow buttons to select the Text Record option from the Alarm menu and press

the OK button.