System information

Chapter 4: IR Remote Control Operation
67
3. Use the Up and Down arrow buttons to select a field to change, from the following options:
Enable -enables the recording schedule.
Mon through Sun - enables recording on the specified days of week.
Start Hour/Minute/Second - sets the exact time when the recording starts.
Stop Hour/Minute/Second - sets the exact time when the recording ends.
Camera 1 through 16 - sets the recording mode for the selected camera. Select Normal Record to record
continuously. Select Motion Detect to record only when motion is detected. Select Text Record to record
only when pos event is detected. Select OFF to disable recording.
Audio - enables recording of sound along with the video signal.
Frame Rate Setup - sets the frame rate for recording. Set Auto Speed to Yes and the device evenly
divides the recording frame rate amongst all cameras. If set to No, you can manually set up the individual
frame rates for each camera.
Weight recording- weight recording is setting special recording frame rate when an alarm of one of
camera was triggered.
4. Use the Right and Left arrow buttons to change the value of that parameter.
5. Use the Prev Page and Next Page buttons to move to the previous or next page.
6. Press the OK button when all parameters are set.
4.4.3 Motion Detection
To set motion detection conditions:
1. Use the Up and Down arrow buttons to select the Motion Detection option from the Alarm menu and
press the OK button.
2. When the motion detection menu appears, uses the Up and Down Arrow buttons to select one of the
following options:
• Enable – configures the motion detection feature for each camera.
• Sensitivity – sets the sensitivity value for detecting motion.
• Set Detect Area – sets the area in the camera’s field of vision over which motion is detected. This
option is displayed only after you set the Enable option to Ye s.
• Enable all area – sets the all area is motion detect area.