System information

Chapter 4: IR Remote Control Operation
65
Test&Save? - tests the server and saves the changes.
To change NTP settings:
1. Use the Up and Down arrow buttons to select a field to change from the NTP menu.
2. Press the Right button to confirm.
3. Press the Key Pad button on the remote control to display the on-screen keyboard.
4. Use the Arrow buttons to select letters from the on-screen keyboard and use the OK button to
confirm.
5. When the field is set correctly, press the Key Pad button on the remote control to turn off the
on-screen keyboard.
6. Press the OK button to save changes.
4.3.19 License Setup
There are two ways to grant POS license. One is key-in license key; the other one is plug-in a key-pro. So
if you plug-in a key-pro you don’t need to key in the license number again in the license setup menu. Use
the License menu to key in the license number. ʳ
There are three POS License to three levels:
Level 1: Single POS unit – Can connect ONLY one cash register.
Single POS only one cash register. This level pos function doesn’t need to register.
Level 2. 4 POS units -- Can connect maximum 4 cash registers.
Level 3. Full functions – Can connect maximum 16 cash registers.
4.4 Record setup
Use the Record Setup menu to set all the record options for the AP-5004. There are four Record Setup
submenus - AP-5004, Record Schedule, Motion Detection, GPI Trigger , Text Record and Pre-Alarm.
This section covers each submenu in turn.