System information

Chapter 4: IR Remote Control Operation
61
2. Use the Left arrow to decrease the value and the Right arrow to increase the value for that field.
3. Press the OK button when the values are set correctly.
Note: The AP-5004 reboots to save the changes, if you modify the time zone.
4.3.13 Alarm
Use the Alarm menu to define what constitutes an alarm condition and how the AP-5004 reacts when
such a condition occurs. You can configure an alarm condition to be generated when motion is detected
by the camera, if the video signal is lost from a camera, if the disk space is too low, if there is a disk error
or if pos event. Once the alarm is generated, you can set the alarm notification through a beep, a message,
a video popup or E-mail.
The Alarm menu has the following submenus:
E-Mail - enables you to set up an E-mail address and verify it is working correctly.
Video Popup (sec) - sets the time for which a camera is displayed on your monitor when an alarm is
generated.
Voice Call – this function is not supported.
Set Action - sets the action that will generate an alarm condition for each camera.
Note: The Voice Call function is not supported.
To enter E-mail details:
1. Select the E-Mail option from the Alarm menu.
2. Press the Right button to confirm. The E-Mail submenu is displayed.
3. In the E-Mail menu, use the Up and Down buttons to select a field from the following:
Addr - Type the name of your mail server. See your network administrator for details about the address of
your mail server.