System information

Chapter 4: IR Remote Control Operation
60
COM1 Device - selects the type the serial device. You can select external modems, GPIO, voice call
modems, etc.
COM1 Speed - sets the speed (1200 to 115200 bps) for the serial device.
COM1 Flow Control - enables or disables the flow control for the device.
COM1 Data Bits - Sets the number of data bits (6, 7, or 8) for the device.
COM1 Parity - Sets odd or even parity.
COM1 Stop Bits - Sets 1 or 2 stop bits for the device.
To change the serial port parameters:
1. Use the Up and Down buttons to select the field to change.
2. Use the Left and Right arrow buttons to cycle through the available options for that field.
3. Press the OK button when the field is set correctly.
Note:
1. You can use the Prev Page and Next Page buttons on the remote control to toggle between the COM1
menu and COM2 menu.
2. When an optional GPIO module is connected to the serial port, the AP-5004 detects it automatically
and provides GPIO options in the system menu.
4.3.11 System information
Use the System Information option to display the System Information screen and view information
about the boot disk, Flash Size,TCP/IP parameters, the MAC ID of the device, firmware version and date
of installation, model number, and hard disk properties.
4.3.12 Date/Time
Use the Date/Time option to set the year, month, day, hour, minute, second, and time zone in which the
AP-5004 is installed.
To set the time or time zone:
1. Use the Up and Down arrow buttons to select the field to change.