Instructions / Assembly

2. Point X Feed water connection:

Tubing color: Red tubing. Connect the RED tubing to the Feed Water Needle Valve.

Fitting type: Metal compression nut fitting. See Fig.1B on page 4. Use plastic sleeve.

Add “insert” to tubing. No teflon tape here. Tighten nut with wrench.

Tips! If Point X leaks after you have tightened the brass nut, check to make sure you did put the

plastic “insert and sleeve” onto the tubing. If the insert is already in place, then try ap-

plying Teflon tape from the threaded metal stud all the way to the plastic tubing, wrap the

whole connection with 8-10 rounds of Teflon tape. Smooth out the tape on the threaded

part with your fingers. Tighten brass nut again. This should stop the leak.

If the plastic sleeve is damaged, you can use the metal sleeve, but you need to apply

Teflon tape as described above, this should stop the leak.

Details on Tubing Connections:

To ensure a smooth and correct installation, please connect the water lines following the se-

quence and order outlined below. Refer to Fig.8 for proper point locations.

1. Point Z Faucet connection:

Tubing color: White tubing. Connect the WHITE tubing to the base of the faucet.

Fitting type: Quick Connect Fitting. Simply push White tubing into Quick Connect fitting. No Insert,

Sleeve or Nut needed here. (Attach threaded end of faucet adapter to the faucet metal

stem. No teflon tape needed here)

3. Point A System water inlet (to Stage 1 filter) connection:

Tubing color: Red tubing. Connect the RED tubing from the Feed Water Valve to stage -1

filter.

Fitting type: Quick Connect fitting See Fig.1 on page 4. Simply push the Red tubing into the Quick

Connect fitting. No Inserts, Sleeves or Nuts are needed to secure the connection. No tef-

lon tape needed here.

4. Point H Stage-3 filtered water to faucet connection:

Tubing color: White tubing. Connect the WHITE tubing from the faucet base stud to the Stage-3 filter’s

outflow end at point H.

Fitting type: Quick Connect fitting See Fig.1 on page 4. Simply push the White tubing into outlet

on the 3rd stage filter. No Inserts, Sleeves or Nuts are needed to secure the

connection. No Teflon tape needed here.