Use and Care Manual

UV BULB INSTALLATION & REPLACEMENT ADDENDUM

I. INSTALL UV BULB INTO UV LIGHT:

Step 1. Open package to check all components inside: UV housing, UV lamp, glass sleeve, O-ring,

electronic ballast (transformer). Note: All components are individually packed.

Step 2. Unscrew end nut from UV housing. See Fig.1.

Step 3. Install o-ring onto the open end of the glass sleeve and insert the glass sleeve all the way

securely into the UV housing. See Fig.2.

Step 4. Hand-screw end nut onto UV housing. To protect the o-ring, do not over tighten.

See Fig.3.

Fig.1 Fig.2

Fig.3

Step 5. Connect the 4 electrical pins from the UV bulb to the transformer. If the pin does not fit, please

rotate the UV bulb and reconnect the transformer pins until there is a proper fit. See Fig.4.

Fig.4

Step 6. Insert the UV bulb all the way into the UV housing securely and make sure the transformer

cover fully covers the UV housing entry point. See Fig.5.

Fig.5

PAGE 1
UV BULB INSTALLATION & REPLACEMENT ADDENDUM I. INSTALL UV BULB INTO UV LIGHT: Step 1. Open package to check all components inside: UV housing, UV lamp, glass sleeve, O-ring, electronic ballast (transformer). Note: All components are individually packed. Step 2. Unscrew end nut from UV housing. See Fig.1. Step 3. Install o-ring onto the open end of the glass sleeve and insert the glass sleeve all the way securely into the UV housing. See Fig.2. Fig.1 Fig.2 Step 4. Hand-screw end nut onto UV housing.
PAGE 2
Congratulations! You have successfully completed the UV bulb installation. Please continue to How to Replace Stage-6 Carbon Filter(Page 22) to complete your filter installation. If you have UV light installed and need to replace UV bulb, please refer to the following instruction: II. UV BULB REPLACEMENT: Replace the UV light bulb after 1 year of service. After 12 months, the UV bulb loses its strength. Prolonged use after 1 year will result in less than optimal performance. Step 1.