Instructions / Assembly

TANK CONNECTION FOR RO SYSTEM WITH UV LIGHT OPTION

Your RO system includes a UV light option. The UV light is added to your system at Stage-5

(before final stage carbon filter). So instead of feeding the tank Yellow tubing to the Stage-5

filter T-fitting, you will now feed the yellow tubing into the UV light T-fitting.

Tank Connection: See Fig. 1 below.

Remove the plastic end plug from the UV Light T-fitting at Point G. To remove the end plug,

push in and hold down on the collet ring squre into the fitting. With the ring in this position, you

can now remove the end plug. Next, connect the Yellow tank tubing to the T-fitting. To connect,

simply push the tubing into the Quick Connect fitting then gently pull back on the tubing to

make sure connection is secured.

Note: The rest of the RO installation is the same as stated in the Installation Manual,

please follow the Manual step by step for all the other connections.

Warning: DO NOT UNSCREW the UV Housing Cap located on the Left Hand Side of the

UV Housing. When replacing the UV light bulb, simply use a Flat Head Screwdriver to pry open

the UV Light Bulb where the Wire enters the UV Housing Cap.

Fig. 1

PAGE 1
TANK CONNECTION FOR RO SYSTEM WITH UV LIGHT OPTION Your RO system includes a UV light option. The UV light is added to your system at Stage-5 (before final stage carbon filter). So instead of feeding the tank Yellow tubing to the Stage-5 filter T-fitting, you will now feed the yellow tubing into the UV light T-fitting. Tank Connection: See Fig. 1 below. Remove the plastic end plug from the UV Light T-fitting at Point G. To remove the end plug, push in and hold down on the collet ring squre into the fitting.