Instructions / Assembly

Step 7: System Start-Up

1. Turn on feed water: Slowly, turn on your cold water supply. Open the Feed Water Ball

Valve to allow the raw water to enter the system. Turn the “handle” to the horizontal position.

Check for leaks!

2. Turn on tank valve: Turn on the tank’s ball valve to allow water to enter the tank. The tank’s

valve is “On” when the valve lever is parallel (in the same direction) with the valve’s outlet

(see Fig.7). Check for leaks!

3. Wait for tank to fill: Before usage, allow the tank to fill. It takes 2-3 hours to fill tank de-

pending on the incoming water pressure.

4. Drain Tank: Do not use the first tank of water! Drain it out to flush the system and

new filters. Lift the faucet lever up into a locked position to drain tank. Let the tank refill

again and the pure water is ready for use.

5. Clean up area: Allow the system to run while cleaning up tools and work area.

6. Check for leaks! Make sure no water is leaking at joints, fittings, valves, and tubing con-

nections.

Congratulations! You have successfully installed the Reverse Osmosis System.

*** End of Installation Section ***