Instructions / Assembly

©2017 APEC Water Systems. All rights reserved. v.2017.1 www.freedrinkingwater.com
DRAIN
LINE
WASTE WATER
INPUT WATER
DRINKING
WATER
TO ICEMAKER OPTION
W
GH
O
A
Z
Y
DRINKING WATER FAUCET
SINK
FI-PHPLUS
P
DRAIN
LINE
WASTE WATER
INPUT WATER
DRINKING
WATER
TO ICEMAKER OPTION
W
G
H
A
Z
Y
DRINKING WATER FAUCET
SINK
FI-PHPLUS
InOut
Fig. 2
Option 1
Option 2
Fig. 3
Fig. 4
Filter Replacement:
Replace pH filter every 6-12 months.
The Calcite media in filter will be depleted
after 6 months.
Replace Filter:
Shut off Cold water supply to RO system. Close
the tank valve. Turn ON the drinking water faucet
to release pressure in system.
Remove old filter from water line. To remove the
tubing Push In and Hold Down on the collet ring
square against the fitting. With the collet held in
this position the tube can be removed.
The new PH filter will come with 2 End Plugs.
Please remove the plugs before connecting the
tubing to the filter.
Turn on Feed water. Open the tank valve. Wait for
RO tank to fill. Flush 2-3 gallons (about 2 tanks)
of water through new filter before using pure
water.
To Disconnect the End Plugs:
Push In and Hold Down on the collet ring square
against the fitting. While holding down the collet
ring, pull out the end plug with your other hand.
Only the plug will slide out from the connection.
(See Fig. 4)