Instructions / Assembly

3
Changing Stage-6 Carbon TCR Filter: (should be changed with the membrane every 2-3 years)
1) Remove the OLD filter: See Fig.B. Disconnect the tubing from Point K and tubing at Point H. To remove tubing, Push In
and Hold Down on the collet ring square against the fitting. With the collet held in this position the tube can be
removed. Use a wrench to unscrew the fittings at ends of the filter where the tubing connected to. You will put these 2
fittings on the new filter. Discard the used filter. The new 6th stage filter will come with 2 plastic end caps. Please use a
flat head screwdriver to remove the caps before proceeding.
2) Sanitize: Use some mild bleach solution to rinse the 2 plastic fittings and the 2 ports of the new filter.
This is to prevent contamination. NOTE: Only this filter change needs bleach sanitizing. Do Not apply chlorine/bleach
in any way to Membrane or it will damage the membrane!
3) Connect the 2 fittings and tubing to the new filter as before. Make sure the “FLOW ” on the filter is pointing to
Point H. Check for leaks!
Fig. C
free drinking water.com