Use and Care Manual

How to Replace Last Stage Post Carbon Filter:

Replace this last filter at the same time you replace the stage-4 membrane.

1. Locate the last stage carbon filter. See Fig 8 on Page 16.

2. Remove the OLD filter: Disconnect the input 3/8” tubing at Point G. and output 3/8” tubing

at Point H. Discard the old filter. (See Fig.6 on Page 10)

To disconnect: Push in and hold down on the collet ring square against the fitting. With the

collet held in this position the tubing can be removed. See Fig.1B on page 3.

3. Remove the 2 end plugs from the new filter to open up the parts.

4. Reconnect the input and output tubing. Make sure the “Flow ” on the filter is pointing to

the pure water output direction.

* * * End of Installation Manual * * *