Use and Care Manual

5
Pull the hose assembly out of the
spout and remove the spray head
by unscrewing it from the hose in a
counterclockwise direction. Be sure to
hold the end of the hose down into the
sink and turn the faucet to the warm
position where it mixes hot and cold
water.
Flush the water lines for two minute.
This ushes away any debris that
could cause damage to internal parts.
Check for leaks.
Re-tighten any connections if neces-
sary, but do not overtighten. Reinstall
the spray head by hand tightening it
back onto the spray hose in a clock-
wise direction.
NOTE: Please make sure washer is
installed attaching spray head to hose.
5