Specifications

SURT Stack/Rack-Mount 12U 14000/18000 VA 200 Vac 15000/20000 VA 208/240 Vac 3
Introduction
Overview
The American Power Conversion (APC
®
) Smart-UPS
®
RT is a high performance uninterruptible power
supply (UPS) that provides protection for electronic equipment (load) from utility power blackouts,
brownouts, sags and surges. The UPS protects electronic equipment from small utility fluctuations and
large disturbances by providing continuous on-line double converted power. The UPS provides battery
backup until utility power returns to safe levels or the batteries are fully discharged.
Inventory
Read the Safety Guide before installing the UPS.
The UPS and the battery pack are shipped together in separate cartons.
Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage.
The packaging is recyclable; save it for reuse or dispose of it properly.
Check the UPS package contents:
NOTE: The model and serial numbers are located on a small, rear panel label. For some models, an
additional label is located on the chassis under the front bezel.
•UPS
• Input wiring tray
• Output wiring tray
• Display interface
• Front bezel
• UPS serial cable
• Network Management Card
(NMC) serial cable
• Jumper cable 25.4 cm (10 in)
•Rail Kit
• Four ornamental screws
• Two cage nuts
• Two rail cleats
• Four pan head screws
• Two rack-mount brackets
• Eight flat head screws
• Temperature sensor-refer to NMC
documentation for installation
instructions
• Literature kit containing:
– Product documentation
– Smart-UPS RT User Manuals CD
– Network Management Card (NMC)
Utility CD
– Network Management Card (NMC)
documentation
– Safety information
– Warranty information
Hardware
4
Pan head screws for securing rail cleats to unit
8
Flat head screws for securing rack-mount or tie brackets to unit
4
Ornamental screws for securing unit to rack
2
Cage nuts used in rack-mount installation
2
Rack-mount brackets
2
Rail cleats