User manual

SURT192RMXLBP2/SURT192RMXLBP2J User Manual 3
Introduction
About this UPS
The American Power Conversion (APC
®
) SURT192RMXLBP2 external battery pack (XLBP) connects to
an APC Smart-UPS
®
RT greater than 10 kVA. Together these units provide extended protection for
electronic equipment (load) from utility power blackouts, brownouts, sags and surges. The UPS and the
XLBP together provide continuous power from the batteries until utility power returns to safe levels or the
batteries are fully discharged.
The UPS and the battery pack are packaged separately.
Unpack package contents
Read the Safety Guide before installing the unit.
Inspect the battery pack upon receipt. Notify the carrier and dealer if there is damage.
The packaging is recyclable; save it for reuse or dispose of it properly.
Check the battery pack package contents:
NOTE: The model and serial numbers are located on a small, rear panel label. For some models, an
additional label is located on the chassis under the front bezel.
• External battery pack
• Front bezel
• Battery compartment doors
• Ground wire
• Four tie brackets
• Sixteen ornamental screws
•Rail Kit
• Four ornamental screws
• Two cage nuts
• Two rail cleats
• Four pan head screws
• Two rack-mount brackets
• Eight flat head screws
• Literature kit containing:
– Product documentation
– Smart-UPS RT User Manuals CD
– Safety information
– Warranty information
Hardware
4
Pan head screws for securing rail cleats to unit
8
Flat head screws for securing rack-mount or tie brackets to unit
20
Ornamental screws:
• 4 for securing unit to rack
• 16 for securing tie brackets in stack configuration
2
Cage nuts used in rack-mount installation
2
Rack-mount brackets
2
Rail cleats
2
Tie brackets for securing units in stack configuration