Datasheet

5 990-1060C 07/2014

3. CONNECT THE BATTERY

1. To connect the battery, push the battery

connector into the receptacle in the battery

compartment. Press firmly to ensure a tight

connection. You will hear a snap when the

connector is seated properly.

2. Push the battery cables and white cord into the

space with the battery connector.

ATTACH BATTERY DOOR AND FRONT BEZEL

1. Replace the battery door and screw the two

battery door screws back into the corners of the

battery door. The battery door will cover the

battery cables and white cord.

2. The UPS is shipped with the front bezel

removed and packed separately within the main

box. Unpack the bezel and hold it with the

cutout section on top. Slide the tab on the bottom

of the bezel into the slot on the bottom of the

UPS. Gently snap the top of the bezel into

place. The bezel can be removed by carefully

unsnapping the top, and then sliding the bezel up

and out of the tab on the bottom of the UPS.

CONNECT THE EQUIPMENT TO THE UPS AND CONNECT THE UPS TO THE AC POWER

UPPLY

1. On the back panel, plug the female end of the power cord into the receptacle. Then plug the

male end into a two-pole, three-wire, ground receptacle. Avoid using extension cords and

adapter plugs.

2. Connect the equipment to the UPS using the power cords provided with the equipment.

3. Turn on all connected equipment. To use the UPS as a master ON/OFF switch, be sure all

connected equipment is switched on. The equipment will not be powered until the UPS is turned

on.