Datasheet

3 990-1060C 07/2014

2: INSTALLATION

UNPACKING

The packaging is recyclable; save it for reuse or dispose of it properly.

Check the package contents. The shipping package contains the UPS (with batteries disconnected);

its front bezel (packaged separately); feet (required in tower configuration); and a literature kit

containing a software CD, one serial cable, power cord(s), screws for the feet, and product

documentation.

The UPS is shipped with the battery disconnected and the front bezel removed. You

will connect the battery and install the plastic bezel (described later) during the

installation procedure.

POSITIONING THE UPS

Place the UPS where it will be used. The UPS is heavy. It requires two people for installation due to

its weight. To lighten the UPS, you may remove the battery while you position the UPS.

See Removing the Battery Pack, below, for instructions. Select a location sturdy enough to handle

the weight.

You must install the UPS in a protected area that is free of excessive dust and has adequate airflow.

Ensure the air vents on the front and rear of the UPS are not blocked. Allow at least one inch of space

on each side.

Do not operate the UPS where the temperature and humidity are outside the specified limits. Refer to

the Specifications at the APC by Schneider Electric web site, www.apc.com.

Placement

Sm ar