Datasheet

1 990-1060C 07/2014

1: SAFETY INFORMATION

The APC

by Schneider Electric Smart-UPS

RT is a high performance, uninterruptible power

supply (UPS). The UPS provides protection for electronic equipment from utility power blackouts,

brownouts, sags, and surges and small utility fluctuations and large disturbances. The UPS also

provides battery backup power for connected equipment until utility power returns to safe levels or

the batteries are fully discharged.

This user manual is available on the enclosed Documentation CD and on the

APC by Schneider Electric web site, www.apc.com.

Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the warranty.

HANDLING SAFETY

Be careful. Do not lift heavy loads without assistance.

<18 kg (<40 lb)

32–55 kg (70–120 lb)

18–32 kg (40–70 lb)

>55 kg (>120 lb)

This equipment is intended for installation in a temperature controlled indoor area free of conductive

contaminants. Refer to Specifications at the APC by Schneider Electric web site for the actual

temperature range.

ELECTRICAL SAFETY

• To reduce the risk of fire, connect only to a circuit provided with a 30 Amp maximum branch

circuit overcurrent protection in accordance with the National Electrical Code ANSI/NFPA or

country specific electrical code.

• Do not work alone under hazardous conditions.

• Check that the power cord(s), plug(s), and sockets are in good condition.

• To reduce the risk of electric shock when grounding, disconnect the equipment from the AC

power outlet before installing or connecting to other equipment. Reconnect the power cord only

after all connections are made.

• Use one hand, whenever possible, to connect or disconnect signal cables to avoid a possible

shock from touching two surfaces with different electrical grounds.

• Connect the equipment to a three wire AC outlet (two poles plus ground). The receptacle must

be connected to appropriate branch circuit/mains protection (fuse or circuit breaker). Connection

to any other type of receptacle may result in a shock hazard.