Operation Manual
Table Of Contents
- General Information
- Important Safety Messages
- Product Handling Guidelines
- Safety and General Information
- FCC Class A Radio Frequency Warning
- Product Description
- Product Overview
- Specifications
- Front panel features
- Rear panel features
- Operation
- Wiring Specifications
- Connect Equipment
- Turn the UPS On/Off
- UPS Display Interface
- Configuration
- UPS Settings
- Controllable Outlet Groups
- Emergency Power Off
- Network Management Interface
- Introduction
- Features
- Related Documents
- IP Address Configuration
- Smart Battery Management
- Troubleshooting
- Transport
- Service
- Limited Factory Warranty
Smart-UPS On-Line SRT5K/6K Tower/Rack-Mount 3U/4U34
The UPS display turns red or amber, displays an alert message, and emits a sustained audible alarm
Red illumination indicates a UPS alarm that requires immediate attention
Amber illumination indicates a UPS alarm that requires attention
There is an internal UPS alert. Do not attempt to use the UPS. Turn the UPS off and have it serviced
immediately.
The UPS is experiencing an overload
condition.
Reduce the load on the UPS. Disconnect nonessential equipment.
The Replace Battery alert is displayed
The battery has a weak charge. Allow the battery to recharge for at least four hours. Then, perform a
UPS Self Test. If the problem persists after recharging, replace the battery.
The replacement battery is not properly
connected.
Be sure the battery cable is securely connected.
Problem and Possible Cause Solution
1/1
Error P.05
Contact Customer Support
Output Off
123
1/1
Output Overload
Backup Not Available
Bypass
123