Operation Manual
Table Of Contents
- General Information
- Important Safety Messages
- Product Handling Guidelines
- Safety and General Information
- FCC Class A Radio Frequency Warning
- Product Description
- Product Overview
- Specifications
- Front panel features
- Rear panel features
- Operation
- Wiring Specifications
- Connect Equipment
- Turn the UPS On/Off
- UPS Display Interface
- Configuration
- UPS Settings
- Controllable Outlet Groups
- Emergency Power Off
- Network Management Interface
- Introduction
- Features
- Related Documents
- IP Address Configuration
- Smart Battery Management
- Troubleshooting
- Transport
- Service
- Limited Factory Warranty
27Smart-UPS On-Line SRT5K/6K Tower/Rack-Mount 3U/4U
Use one of the following cable types to connect the UPS to the EPO switch.
• CL2: Class 2 cable for general use.
• CL2P: Plenum cable for use in ducts, plenums, and other spaces used for environmental air.
• CL2R: Riser cable for use in a vertical run in a floor to floor shaft.
• CLEX: Limited use cable for use in dwellings and for use in raceways.
• Installation in Canada: Use only CSA certified, type ELC, (extra low voltage control cable).
• Installation in countries other than Canada and the USA: Use standard low voltage cable in accordance with
national and local regulations.