Operation Manual

UPS Menu Overview
Main Menu
Status
Control
Configuration
Test And Diagnostics
Log
About
Config Menu
UPS
Battery
Outlets
Communication
Display
Status Menu***
UPS
Battery
Accessory
Control Menu**
UPS
Bypass Control
Outlet Group 1*
Outlet Group 2*
Clear Alarms
Test and Diagnostics Menu
UPS Self Test
Runtime Test
Alarm Test - Short
Alarm Test - Continuous
Log
Event Log
Battery
RBC Health
RBC Summary – Installed MMYY, Replace MMYY
Internal RBC’s, Battery Packs, External RBC’s
Charge %, Runtime
Temperature, Voltage
Internal Pack – Temperature
Internal Pack – Health
External Pack – Temperature
External Pack - Health
UPS**
Efficiency
Output Power - Watts, VA,Load %
Output - Voltage, Frequency, Current
Energy Usage
Battery - Charge %, Runtime
- Input Voltage, Frequency
Self TestUPS
Runtime Test
Outlet Group 1**
Turn On Immediately
Turn On With Delay
Turn Off Immediately
Turn Off With Delay
Reboot Immediately
Reboot With Delay
Shutdown Immediately
Shutdown With Delay
Outlet Group 2**
Turn On Immediately
Turn On With Delay
Turn Off Immediately
Turn Off With Delay
Reboot Immediately
Reboot With Delay
Shutdown Immediately
Shutdown With Delay
Bypass Control**
Go into Bypass
Go out of Bypass
Clear Alarms**
No Alarms Exist
UPS**
Turn On Immediately
Turn On With Delay
Turn Off Immediately
Turn Off With Delay
Reboot Immediately
Reboot With Delay
Shutdown Immediately
Shutdown With Delay
Outlets
Main Outlet
Outlet Group 1
Outlet Group 2
Outlet Group 3
Display
Language
Audible Alarm – Disable, Enable
LCD Backlight – Always On, Auto Dim, Auto Off
LCD Settings- Color, Brightness, Contrast
Menu type - Standard / Advanced
Time***
UPS**
Green Mode - Enable / Disable
Output Setting - Lower Volt, Upper Volt
Output Setting – Acceptable Frequency
Output Setting – Frequency Slew Rate
Bypass Settings - Lower Volt, Upper Volt
Bypass Settings – Frequency
Battery Settings – Low Runtime Alert
Self Test Schedule
Alert Setting - Site Wiring Fault
PDU model -
Standard, SRT001, SRT004, SRT005, SRT015
Default Setting
Energy Meter*
Battery
Install Date
Replace Notification
Replace Battery Alarm
Communication
Network - IP Address mode, IPV4 Address
Modbus*- Enable / Disable, Address
SmartSlot- IP Address Mode, IPv4 Address***
UPS***
UPS Hardware
PDU Hardware
UPS Hardware - Serial No.
UPS Hardware - Manufacture Date
UPS Firmware – Revision
UPS – DSP Firmware
UPS – Comm Firmware
UPS Time
About Menu***
UPS
Battery
Accessory
Battery
RBC Summary - Installed MMYY, Replace MMYY
Battery – Firmware
Battery – Part No.
Menus are subject to change depending on the installed firmware version
* Available on the Advanced Menu Screens
** Options displayed will vary based on UPS state.
*** Options displayed will vary based on connected accessories.
**** Disabled when AP9629 card is installed in the UPS.
suo1432a
Accessory***
Smart Slot – Probe 1 Temperature
Smart Slot – Probe 1 Humidity
Smart Slot – Probe 1 Relay I/O Status
Smart Slot – Probe 2 Temperature
Smart Slot – Probe 2 Humidity
Smart Slot – Probe 2 Relay I/O Status
Accessory***
Network - MAC Address
Network - IP Address
Smart Slot - Serial No.
Smart Slot - Part No.
Smart Slot - Firmware
Smart Slot - MAC Address
Smart Slot – IPv4 Address