Operation Manual
Table Of Contents
- General Information
- Important Safety Messages
- Product Handling Guidelines
- Safety and General Information
- FCC Class A Radio Frequency Warning
- Product Description
- Product Overview
- Specifications
- Front panel features
- Rear panel features
- Operation
- Wiring Specifications
- Connect Equipment
- Turn the UPS On/Off
- UPS Display Interface
- Configuration
- UPS Settings
- Controllable Outlet Groups
- Emergency Power Off
- Network Management Interface
- Introduction
- Features
- Related Documents
- IP Address Configuration
- Smart Battery Management
- Troubleshooting
- Transport
- Service
- Limited Factory Warranty
Smart-UPS On-Line SRT5K/6K Tower/Rack-Mount 3U/4U16
Connect Equipment
Note: The UPS batteries will charge to 90% capacity in the first three hours of normal operation. Do not expect
full battery runtime capability during this initial charge period.
1. Connect the internal battery module. See Installation manual for details.
2. Connect equipment to the outlets on the rear panel of the UPS.
Refer to “Controllable Outlet Groups” on page 25.
3. Connect the UPS to the building utility power.
Turn the UPS On/Off
The first time the UPS is turned on the Setup Wizard screen will run. Follow the prompts to configure UPS
settings. Refer to “Configuration” on page 20.
To turn on the UPS and all connected equipment, press the Power
ON/OFF button on the display panel. Follow the
prompts to either turn the UPS on immediately or after a delay, then press OK.
Note: When there is no input power and the UPS is off, the cold start feature can be used to turn on the UPS and
connected equipment using battery power.
To perform a cold start press the Power ON/OFF button.
The display panel will illuminate and the Power ON/OFF button will illuminate red.
To turn on the output power press the Power ON/OFF button again. Select the prompt Turn ON with NO AC and
press OK.
To turn output power off, press the Power
ON/OFF button. Follow the prompts to either turn the UPS off
immediately or after a delay, then press OK.
Note: Once the AC power has been turned off the UPS will continue operating on battery power for a short period
of time. To remove power completely press the Power ON/OFF button. Follow the prompt to select Internal Power
Off, then press OK.
CAUTION
RISK OF ELECTRIC SHOCK
• Disconnect the mains input circuit breaker before installing or servicing the UPS or connected
equipment.
• Disconnect internal and external batteries before installing or servicing the UPS or connected
equipment.
• The UPS contains internal and external batteries that may present a shock hazard even when
disconnected from the mains.
• UPS AC hardwired and pluggable outlets may be energized by remote or automatic control at any time.
• Disconnect equipment from the UPS before servicing any equipment.
• Do not use the UPS as a safety disconnect.
Failure to follow these instructions can result in minor or moderate injury.