Operation Manual
Table Of Contents
- General Information
- Important Safety Messages
- Product Handling Guidelines
- Safety and General Information
- FCC Class A Radio Frequency Warning
- Product Description
- Product Overview
- Specifications
- Front panel features
- Rear panel features
- Operation
- Wiring Specifications
- Connect Equipment
- Turn the UPS On/Off
- UPS Display Interface
- Configuration
- UPS Settings
- Controllable Outlet Groups
- Emergency Power Off
- Network Management Interface
- Introduction
- Features
- Related Documents
- IP Address Configuration
- Smart Battery Management
- Troubleshooting
- Transport
- Service
- Limited Factory Warranty
13Smart-UPS On-Line SRT5K/6K Tower/Rack-Mount 3U/4U
Reset button Use the Reset button to restart the Network Management Interface.
Note: A restart of the Network Management Interface does not affect UPS operation.
AC input
power cable or
hardwire input
box
• SRT5KXLT, SRT5KRMXLT, SRT5KXLT-IEC, SRT5KRMXLT-IEC models have factory
installed input power cables.
• All other models are equipped with a hardwire input box.
Refer to “Wiring Specifications” on page 14.
Remove the knockouts. Snap-In strain reliefs are recommended (not supplied).
Controllable
outlet group 1
Connect electronic devices to these outlets.
Controllable
outlet group 2
Connect electronic devices to these outlets.
Controllable
outlet group 3
Connect electronic devices to these outlets.
Circuit breaker In the event an overload condition occurs, disconnect nonessential equipment.
Then reset the circuit breaker.