Operation Manual
Table Of Contents
- General Information
- Important Safety Messages
- Product Handling Guidelines
- Safety and General Information
- FCC Class A Radio Frequency Warning
- Product Description
- Product Overview
- Specifications
- Front panel features
- Rear panel features
- Operation
- Wiring Specifications
- Connect Equipment
- Turn the UPS On/Off
- UPS Display Interface
- Configuration
- UPS Settings
- Controllable Outlet Groups
- Emergency Power Off
- Network Management Interface
- Introduction
- Features
- Related Documents
- IP Address Configuration
- Smart Battery Management
- Troubleshooting
- Transport
- Service
- Limited Factory Warranty
Smart-UPS On-Line SRT5K/6K Tower/Rack-Mount 3U/4U12
Key to identify rear panel features
SRT6KXLT-IEC/SRT6kRMXLT-IEC
SmartSlot The SmartSlot can be used to connect optional management accessories.
External battery
power and
communication
connector
Use the external battery cable on the XLBP to connect the UPS and XLBP.
XLBPs provide extended runtime during power outages. The UPS will automatically recognize
up to 10 external battery packs.
Chassis ground
screws
The UPS and XLBPs have ground screws for connecting the ground leads. Prior to connecting
a ground lead, disconnect the UPS from mains power.
Hardwire
output box
SRT5KRMXLW-HW, SRT6KXLI, SRT6KRMXLI, SRT6KXLT, SRT6KRMXLT,
SRT6KXLT-IEC, SRT6KRMXLT-IEC models are equipped with a hardwire output box.
Refer to “Wiring Specifications” on page 14 for hardwire specifications.
Remove the knockouts. Snap-In strain reliefs are recommended (not supplied).
EPO terminal The Emergency Power Off (EPO) terminal allows the user to connect the UPS to a central EPO
system.
Serial Com The Serial Com port is used to communicate with the UPS.
Use only interface kits supplied or approved by APC by Schneider Electric. Any other
serial interface cable will be incompatible with the UPS connector.
USB port The USB port is used to connect either a server for native operating system communications, or
for software to communicate with the UPS.
Universal I/O
port
Use to connect:
• Temperature sensor AP9335T (supplied)
• Temperature/humidity sensor AP9335TH (not supplied)
• Relay input/output connector AP9810 (not supplied), supports two input contacts and one
output relay
Console port Use the Console port to configure the network management features.
Network port Use the Network port to connect the UPS to the network.
su0884a
GROUP 1
15 AMP MAX
G
R
O
U
P
2
2
0
A
M
P
M
A
X
O
u
t
p
u
t
:
5
0
/
6
0
H
z
2
0
8
/
2
4
0
V
A
C
G
R
O
U
P
3
2
0
A
M
P
M
A
X