Owners manual

29Smart-UPS On-Line SRT5K/6K Tower/Rack-Mount 3U/4U
The UPS display turns red or amber, displays an alert message, and emits a sustained audible alarm
Red illumination indicates a UPS alarm that requires immediate attention
Amber illumination indicates a UPS alarm that requires attention
There is an internal UPS alert or warning. Do not attempt to use the UPS. Turn the UPS off and have it serviced immediately.
The UPS is experiencing an overload
condition.
Reduce the load on the UPS. Disconnect nonessential equipment.
The Replace Battery alert is displayed
The battery has a weak charge. Allow the battery to recharge for at least four hours. Then, perform a
UPS Self Test. If the problem persists after recharging, replace the battery.
The replacement battery is not properly
connected.
Be sure the battery cable is securely connected.
UPS reports; Battery Sys Error 0800 or Needs Firmware Update
UPS reports; Battery Sys Error 0800 or
Needs Firmware Update
The UPS system firmware must be updated to correct this problem.
To update the UPS system firmware go to www.apc.com/support.
Select Search the Knowledge Base and search for FA164737.
Follow the instructions to upgrade the firmware.
Problem and Possible Cause Solution
1/1
Power Sys Error - 00100
Contact Customer Support
Output Off
123
1/1
Output Overload
Bypass
123